GEORGzer Community moderator
Kommentare
Neueste Aktivität von GEORGzer
-
I don’t think there is a way. They will be on holiday break I suppose, but should be back soon.
- Kommentar anzeigen
- 0 Stimmen
-
I hope they get back to you soon 👍
- Kommentar anzeigen
- 0 Stimmen
-
Black/Grey never carry any current. Those two only get bridged together internally when the Relais switches on (analog installment). And they are also for data communication (OpenTherm).
- Kommentar anzeigen
- 0 Stimmen
-
Maybe this video will help you. https://youtu.be/7TJ_yPu_fkM?si=ajn35UjK37Q0zdC2
- Kommentar anzeigen
- 0 Stimmen
-
Not with a Netatmo Valve at least, those are only suited for radiators since they take their own measurements. You would need to use an actuator for the floor-heating zone and hook that one up to t...
- Kommentar anzeigen
- Bearbeitet
- 0 Stimmen
-
https://helpcenter.netatmo.com/hc/en-us/community/posts/21896243366418-Video-unavailable-Insufficient-power-source?page=1#community_comment_22076606898962 V8-2A is recommend
- Kommentar anzeigen
- 0 Stimmen
-
Those mixed systems are a pain 😅 See this thread, basically the same scenario. https://helpcenter.netatmo.com/hc/en-us/community/posts/21875715778066-Thermostatic-valve-and-floor-heating Floor-heat...
- Kommentar anzeigen
- Bearbeitet
- 0 Stimmen
-
Ok I think we found a possible solution for your specific scenario. Turns out it won‘t be as simple as just buying another Thermostat because the software wouldn‘t allow that one to control the boi...
- Kommentar anzeigen
- 0 Stimmen
-
Controlling is the issue here. You need an input (Room Thermostat) that powers the Actuator only when heat is needed in that area, but also communicates with the Netatmo Thermostat connected to you...
- Kommentar anzeigen
- Bearbeitet
- 0 Stimmen
-
Thank you for explaining. I‘m afraid this will be a tricky one since you have a mixed system. You would basically need a 10th Radiator Valve for the floor-heating zone, but this won‘t work properl...
- Kommentar anzeigen
- 0 Stimmen