GEORGzer Community moderator
Comentarios
Actividad reciente de GEORGzer
-
If it’s bought recently, contact your reseller and ask for a warranty replacement.
- Ver comentario
- 0 votos
-
If it closes when the Thermostat should be off, then the polarity is switched in the settings. If really nothing happens whatsoever, then I‘m afraid your Relais is defective.
- Ver comentario
- 0 votos
-
If it works fine, why spend money 🤷♂️
- Ver comentario
- 0 votos
-
The Netatmo Smart Modulating Thermostat will check OpenTherm compatibility and if your Boiler doesn't support that, it will work as a dry-contact thermostat, like the Netatmo Smart Thermostat.
- Ver comentario
- 0 votos
-
If it’s the Smart Thermostat and not the Smart Modulating Thermostat, you can make a simple test by disconnecting the Thermostat/Relais from the boiler and put a jumper-wire in instead. If your boi...
- Ver comentario
- Editado
- 0 votos
-
If I remember correctly, the Thermostat can switch up to 4 Amps. It‘s listed in the technical specs somewhere. It is true that the Thermostat can be placed in a room together with Valves and act as...
- Ver comentario
- Editado
- 0 votos
-
Double check your systems mode settings. https://helpcenter.netatmo.com/hc/en-us/articles/360021261971-The-radiators-in-one-of-my-rooms-are-not-giving-off-enough-heat-even-though-the-room-is-not-at...
- Ver comentario
- 0 votos
-
Netatmo Valves as an actuator won't work well since they will take the temperature measurements wherever the splitter will be located and not in the room. There are installations where the single v...
- Ver comentario
- Editado
- 0 votos
-
You can in theory just use normal or your existing actuators and wire standard relays in parallel. You need something that closes the control circuit of your boiler (like the Netatmo Relais does) w...
- Ver comentario
- 0 votos
-
Since the OP with the mixed system never reported back if they were successful or not, I can‘t really recommend a solution for something like this. In the end, it will remain a „hack“ that requires...
- Ver comentario
- 0 votos