pierre.koever
Opmerkingen
Recente activiteit van pierre.koever
-
I have two cameras now, one is working fine, and the other has this bugging issue of disconnecting. So it's definately NOT the network or the setup. But what is it then ? Switching off/on, resettin...
- Opmerking weergeven
- 0 stemmen
-
No luck for me trying the steps described above by mpchurchill.I tried it several times, adding the sensor to both cameras that I run - no difference. The sensor just cannot be calibrated successfu...
- Opmerking weergeven
- 0 stemmen
-
@Alex: For me, it was a defect of the camera. Netatmo were kind enough to exchange it on warranty.All runs well now; I just was puzzled why I would not be able to make it work stably, and was looki...
- Opmerking weergeven
- 1 stem
-
I'm just not getting the camera to run stable. At every re-start, all works well (either cable or WLAN), but then, after a few hours, it starts disconnecting and finally completely disconnets and n...
- Opmerking weergeven
- 1 stem
-
Same here. Went through all suggestions in this forum. Now plugged a cable; still the same. Will try the suggesiton above with the fixed IP. Annoying.
- Opmerking weergeven
- 1 stem
-
Same here. Thought it was because of the WLAN, set it to 2.4 GHz only; no change. Plugged it to Ethernet cable; still the same. Will try fixed IP next, but this is bugging.
- Opmerking weergeven
- 1 stem