pierre.koever
Opmerkingen
Recente activiteit van pierre.koever
-
I also have one sensor out of 6 that behaves "different": difficult to pair with the camera, and simply impossible to calibrate. Trief it on two different cameras, standing next to each other, no w...
- Opmerking weergeven
- 0 stemmen
-
Also with v5.22.0, I got one camera working perfectly fine, and the other keeps losing the network; however, they stand next to each other.Also, the "bad" one keeps losing the siren. And now, with ...
- Opmerking weergeven
- 0 stemmen
-
Got two indoor cameras; one loaded the update to v5.24.0, the other keeps looping for days to trying to load and install. Anything that I can do to force the install ?
- Opmerking weergeven
- 0 stemmen
-
I have two cameras in the menatime, one is working fine, and the other has this bugging issue of disconnecting several times a day and immediately reconnecting. So it's definately NOT the network o...
- Opmerking weergeven
- 0 stemmen
-
I have two cameras now, one is working fine, and the other has this bugging issue of disconnecting. So it's definately NOT the network or the setup. But what is it then ? Switching off/on, resettin...
- Opmerking weergeven
- 0 stemmen
-
No luck for me trying the steps described above by mpchurchill.I tried it several times, adding the sensor to both cameras that I run - no difference. The sensor just cannot be calibrated successfu...
- Opmerking weergeven
- 0 stemmen
-
@Alex: For me, it was a defect of the camera. Netatmo were kind enough to exchange it on warranty.All runs well now; I just was puzzled why I would not be able to make it work stably, and was looki...
- Opmerking weergeven
- 1 stem
-
I'm just not getting the camera to run stable. At every re-start, all works well (either cable or WLAN), but then, after a few hours, it starts disconnecting and finally completely disconnets and n...
- Opmerking weergeven
- 1 stem
-
Same here. Went through all suggestions in this forum. Now plugged a cable; still the same. Will try the suggesiton above with the fixed IP. Annoying.
- Opmerking weergeven
- 1 stem
-
Same here. Thought it was because of the WLAN, set it to 2.4 GHz only; no change. Plugged it to Ethernet cable; still the same. Will try fixed IP next, but this is bugging.
- Opmerking weergeven
- 1 stem