GEORGzer Community moderator
Kommentare
Neueste Aktivität von GEORGzer
-
Since your Relais is connected to the boilers power supply, it also restarts when you power cycle the boiler, right? Have you tried only power cycling the Relais to check if everything works again...
- Kommentar anzeigen
- 0 Stimmen
-
A replacement outdoor module can be purchased in the shop. https://www.netatmo.com/en-eu/additional-smart-outdoor-module?srsltid=AfmBOoobk-ZvICyUN_8Nvd0svhSfQGP-Nxi3g5d6ZvhAQa8H90NBDyEj
- Kommentar anzeigen
- 0 Stimmen
-
You‘re right, there seems to be an issue with the site. However I discovered that it works from the german support article and then the language can be switched back to english 🤷♂️ Try this link ...
- Kommentar anzeigen
- 0 Stimmen
-
Check the battery compartment for humidity, maybe the batteries got shorted out. Hardware defect would be another possibility.
- Kommentar anzeigen
- 0 Stimmen
-
If you go to settings - advanced, you should see 3 entries if you have a Home Coach devices. By tapping each you can name them, configure the light and so on. To find out which is which name them i...
- Kommentar anzeigen
- Bearbeitet
- 0 Stimmen
-
Ok, that’s actually hard to diagnose from a distance. If your boiler doesn’t react at all to the Thermostat and wiring is legit, there is always the possibility of a hardware defect. However, I do...
- Kommentar anzeigen
- 0 Stimmen
-
You mean a B1KC, not BK1C right? Does the boiler display any error code, like A9? Which would be „Communication error, OpenTherm device“.
- Kommentar anzeigen
- 0 Stimmen
-
Take a look here, you can order spare parts from Netatmo directly: https://helpcenter.netatmo.com/hc/en-us/articles/20976487478162-I-lost-or-broke-a-part-of-my-Outdoor-Camera-how-do-I-get-a-new-one
- Kommentar anzeigen
- Bearbeitet
- 0 Stimmen
-
This boiler uses EMS as its BUS protocol, not OpenTherm like the Netatmo Modulating Thermostat. There are EMS to OpenThem converters out there, but I can‘t say if they work properly or not, sorry.
- Kommentar anzeigen
- 0 Stimmen
-
That sounds more like an operating error to me. Normally you set a heating-circuit temperature on the boiler (many have those typical turning knobs for that), switch it on and leave that as is. Fro...
- Kommentar anzeigen
- Bearbeitet
- 0 Stimmen