I have a house with two mixes zones , radiators and floor heat and i need to replace a Computherm Q8 dual zone thermostat to a Protherm Boiler
I just bought a Netatmo starter kit but Most probably i need to aquaire a second relay/thermostat
But i couldnt find any video/document how to conect the two relays to a existent boiler taking into consideration for the Computherm Q8 there is a separate panel where the zones are installed
Thanks
No, you don't need a second relay, because only one relay can be connected to your boiler/heater. You need to buy an extension kit of smart radiator valves (for the amount of radiators you have in your house) and, if at all possible, an extension kit of a smart thermostat. But I don't really know if Netatmo sells a smart thermostat as an extension kit.
Those can all be connected to one relay (the one you probably already have), just read the instructions of the extension kit.
0
dorel.bota
Modifié
I don’t Know what mean by extension kit i need to buy , i have the starter pack which include 3 valves ( i have 3 radiators ) a relay and a thermostat If i connect the relay to the boiler where should i connect the wire cable from the floor heating ( now that goes into the Computherm Q8 control not on the boiler )
0
p.j.vanderkort
What an extension kit is, you can see on the website of Netatmo, it is a kit with just the radiator valves and nothing else (there is no relay)
Given your installation, I do not think it is possible to use the Netatmo kit on your system. It does not seem to work with floor heating. See the website.
Floor-heating can only be controlled with an extra Netatmo Thermostat. But connecting that Relais and the other one for the Valves to the same boiler, avoiding that one system triggers the other is quiet complex.
Commentaires
4 commentaires
No, you don't need a second relay, because only one relay can be connected to your boiler/heater. You need to buy an extension kit of smart radiator valves (for the amount of radiators you have in your house) and, if at all possible, an extension kit of a smart thermostat. But I don't really know if Netatmo sells a smart thermostat as an extension kit.
Those can all be connected to one relay (the one you probably already have), just read the instructions of the extension kit.
I don’t Know what mean by extension kit i need to buy , i have the starter pack
which include 3 valves ( i have 3 radiators ) a relay and a thermostat
If i connect the relay to the boiler where should i connect the wire cable
from the floor heating ( now that goes into the Computherm Q8 control not on the boiler )
What an extension kit is, you can see on the website of Netatmo, it is a kit with just the radiator valves and nothing else (there is no relay)
Given your installation, I do not think it is possible to use the Netatmo kit on your system. It does not seem to work with floor heating. See the website.
Those mixed systems are a pain 😅
See this thread, basically the same scenario.
https://helpcenter.netatmo.com/hc/en-us/community/posts/21875715778066-Thermostatic-valve-and-floor-heating
Floor-heating can only be controlled with an extra Netatmo Thermostat. But connecting that Relais and the other one for the Valves to the same boiler, avoiding that one system triggers the other is quiet complex.
Vous devez vous connecter pour laisser un commentaire.