GEORGzer Community moderator
Activiteitenoverzicht
Nieuwste activiteit door GEORGzer
-
GEORGzer heeft een opmerking geplaatst,
Check the battery compartment for humidity, maybe the batteries got shorted out. Hardware defect would be another possibility.
- Opmerking weergeven
- 0 stemmen
-
GEORGzer heeft een opmerking geplaatst,
If you go to settings - advanced, you should see 3 entries if you have a Home Coach devices. By tapping each you can name them, configure the light and so on. To find out which is which name them i...
- Opmerking weergeven
- Bewerkt
- 0 stemmen
-
GEORGzer heeft een opmerking geplaatst,
Ok, that’s actually hard to diagnose from a distance. If your boiler doesn’t react at all to the Thermostat and wiring is legit, there is always the possibility of a hardware defect. However, I do...
- Opmerking weergeven
- 0 stemmen
-
GEORGzer heeft een opmerking geplaatst,
You mean a B1KC, not BK1C right? Does the boiler display any error code, like A9? Which would be „Communication error, OpenTherm device“.
- Opmerking weergeven
- 0 stemmen
-
GEORGzer heeft een opmerking geplaatst,
Take a look here, you can order spare parts from Netatmo directly: https://helpcenter.netatmo.com/hc/en-us/articles/20976487478162-I-lost-or-broke-a-part-of-my-Outdoor-Camera-how-do-I-get-a-new-one
- Opmerking weergeven
- Bewerkt
- 0 stemmen
-
GEORGzer heeft een opmerking geplaatst,
This boiler uses EMS as its BUS protocol, not OpenTherm like the Netatmo Modulating Thermostat. There are EMS to OpenThem converters out there, but I can‘t say if they work properly or not, sorry.
- Opmerking weergeven
- 0 stemmen
-
GEORGzer heeft een opmerking geplaatst,
That sounds more like an operating error to me. Normally you set a heating-circuit temperature on the boiler (many have those typical turning knobs for that), switch it on and leave that as is. Fro...
- Opmerking weergeven
- Bewerkt
- 0 stemmen
-
GEORGzer heeft een opmerking geplaatst,
„only the hot water is activated and the radiator boiler does not activate“ You mean hot water like in your bathtub/shower but radiator heating didn‘t work before either?
- Opmerking weergeven
- 0 stemmen
-
GEORGzer heeft een opmerking geplaatst,
TA1 should be the correct terminal to connect a thermostat. Unless another thermostat was installed before, there should be a bridge cable that has to be removed before connecting the Netatmo Therm...
- Opmerking weergeven
- 0 stemmen
-
GEORGzer heeft een opmerking geplaatst,
Il n'y a pas de risque de conflit puisque tout ce que fait le Relais est de fermer le circuit entre les fils noirs et gris, ils ne fournissent aucun courant électrique. Ainsi, avoir deux d'entre eu...
- Opmerking weergeven
- Bewerkt
- 0 stemmen