Installation or reinstallation of the Weather Station and its modules
This section is dedicated to installing or reinstalling your Weather Station, as well as adding accessory modules using your computer (Mac / PC / Linux).
1. Installation / reinstallation of the Weather Station
To perform an alternative installation or reinstallation, download and open the setup assistant corresponding to your operating system:
Wizard for Mac
Wizard for Windows
Wizard for Linux
Then follow the on-screen steps:
- Click Next.
- Connect your station to the computer using the USB cable.
- Set up the Wi-Fi or choose the option Install as a new Station
(this option will permanently erase all data associated with the station).
If detection issues occur, try another USB cable or port, or make sure your antivirus isn’t blocking USB connections.
Once the station is configured, unplug the USB cable and plug the station into its power supply.
2. Installation of additional modules
To install or reconfigure additional modules (e.g. indoor/outdoor module, rain gauge, anemometer), use the Module Manager for your system:
Module Manager for Windows
Module Manager for MacOS
Open the Module Manager and follow the on-screen instructions to link your modules to the main station.
If you experience difficulties adding a module, make sure the station is properly connected, its Wi-Fi is active, and the module is close by during pairing.
This computer-based method allows you to reset your station, reconfigure its Wi-Fi, and easily add or reinstall all your modules.
Updated