GEORGzer Community moderator
Activity overview
Latest activity by GEORGzer
-
GEORGzer commented,
Check the battery compartment for humidity, maybe the batteries got shorted out. Hardware defect would be another possibility.
- View comment
- 0 votes
-
GEORGzer commented,
If you go to settings - advanced, you should see 3 entries if you have a Home Coach devices. By tapping each you can name them, configure the light and so on. To find out which is which name them i...
- View comment
- Edited
- 0 votes
-
GEORGzer commented,
Ok, that’s actually hard to diagnose from a distance. If your boiler doesn’t react at all to the Thermostat and wiring is legit, there is always the possibility of a hardware defect. However, I do...
- View comment
- 0 votes
-
GEORGzer commented,
You mean a B1KC, not BK1C right? Does the boiler display any error code, like A9? Which would be „Communication error, OpenTherm device“.
- View comment
- 0 votes
-
GEORGzer commented,
Take a look here, you can order spare parts from Netatmo directly: https://helpcenter.netatmo.com/hc/en-us/articles/20976487478162-I-lost-or-broke-a-part-of-my-Outdoor-Camera-how-do-I-get-a-new-one
- View comment
- Edited
- 0 votes
-
GEORGzer commented,
This boiler uses EMS as its BUS protocol, not OpenTherm like the Netatmo Modulating Thermostat. There are EMS to OpenThem converters out there, but I can‘t say if they work properly or not, sorry.
- View comment
- 0 votes
-
GEORGzer commented,
That sounds more like an operating error to me. Normally you set a heating-circuit temperature on the boiler (many have those typical turning knobs for that), switch it on and leave that as is. Fro...
- View comment
- Edited
- 0 votes
-
GEORGzer commented,
„only the hot water is activated and the radiator boiler does not activate“ You mean hot water like in your bathtub/shower but radiator heating didn‘t work before either?
- View comment
- 0 votes
-
GEORGzer commented,
TA1 should be the correct terminal to connect a thermostat. Unless another thermostat was installed before, there should be a bridge cable that has to be removed before connecting the Netatmo Therm...
- View comment
- 0 votes
-
GEORGzer commented,
Il n'y a pas de risque de conflit puisque tout ce que fait le Relais est de fermer le circuit entre les fils noirs et gris, ils ne fournissent aucun courant électrique. Ainsi, avoir deux d'entre eu...
- View comment
- Edited
- 0 votes