GEORGzer Community moderator
Comments
Recent activity by GEORGzer
-
„only the hot water is activated and the radiator boiler does not activate“ You mean hot water like in your bathtub/shower but radiator heating didn‘t work before either?
- View comment
- 0 votes
-
TA1 should be the correct terminal to connect a thermostat. Unless another thermostat was installed before, there should be a bridge cable that has to be removed before connecting the Netatmo Therm...
- View comment
- 0 votes
-
Il n'y a pas de risque de conflit puisque tout ce que fait le Relais est de fermer le circuit entre les fils noirs et gris, ils ne fournissent aucun courant électrique. Ainsi, avoir deux d'entre eu...
- View comment
- Edited
- 0 votes
-
Oui, vous pouvez le faire, il suffit de câbler les fils noirs/gris en parallèle. Original answer since I don’t speak french 😅: Yes you can do that, just wire the black/grey wires in parallel.
- View comment
- Edited
- 0 votes
-
Glad it‘s working now. Polarity of the black/grey wires is not important, they never carry any currency. All that happens when the Thermostat switches on is that those two wires get bridged interna...
- View comment
- 0 votes
-
Hm, without looking up this brand any closer I can say that connecting the black/grey wires to BUS is not correct. You have to connect them where the jumper cable was.
- View comment
- 0 votes
-
Did they come with the base? Are they on the base, so powered on and if so, do they flash red periodically?
- View comment
- 0 votes
-
Sorry to hear that. Maybe they will respond now since the holidays have passed.
- View comment
- 0 votes
-
Manual mentions an „OpenTherm Extension“ but I wasn’t able to obtain more information, sorry.
- View comment
- 0 votes
-
Take a look here, Wind Gauge „L. Base“ is the last one in the list. https://helpcenter.netatmo.com/hc/en-us/articles/21894924977810-I-have-lost-or-broken-a-part-of-my-Weather-Station-module-how-can...
- View comment
- Edited
- 0 votes