GEORGzer Community moderator
Comments
Recent activity by GEORGzer
-
If you choose the outdoor module on the right side, expand it and then select the temperature section, you will see it in the big graph. It should remember what you selected for the big graph for n...
- View comment
- Edited
- 0 votes
-
The Relais acts as the „bridge“ to convert the radio signal from the Valves to wifi. Wifi on the Valves directly would be too hard on the batteries. If there really is no spot in your place where ...
- View comment
- 0 votes
-
„By inviting they can’t hush“ Ok, didn’t know that either. So we both learned something today 🤗
- View comment
- 0 votes
-
Great, thanks for letting us know 👍
- View comment
- 0 votes
-
Take a look here, make sure you have the correct mode set. https://helpcenter.netatmo.com/hc/en-us/articles/360021261971-The-radiators-in-one-of-my-rooms-are-not-giving-off-enough-heat-even-though...
- View comment
- 0 votes
-
Take a look here, make sure you have the correct mode set. https://helpcenter.netatmo.com/hc/en-us/articles/360021261971-The-radiators-in-one-of-my-rooms-are-not-giving-off-enough-heat-even-though...
- View comment
- 0 votes
-
No workaround so far, sorry. It literally has been like that since the first introduction of the Thermostat, I doubt they ever gonna change it.
- View comment
- 0 votes
-
You can use any thermal 230V actuator. The important part is, that this actuator fits your heating block.
- View comment
- 0 votes
-
The Relais has two cables with two wires each. The brown/blue wires need to be connected to a power source. The grey/black wires never carry any current. All that happens when the Relais turns on i...
- View comment
- Edited
- 0 votes
-
Yes, then both apartments can start the boiler and operate individually. To be clear, I‘m talking about the classic Netatmo Thermostat, not the modulating one.
- View comment
- 0 votes